Appendix A: Frequently Asked Questions

## A Frequently Asked Questions

This appendix contains the following questions.

- Where do I start to debug a test failure?

- How do I restart a crashed test run?

- What would cause tests be added to the exclude list?

### A.1 Where do I start to debug a test failure?

From the JavaTest GUI, you can view recently run tests using the Test Results Summary, by selecting the red Failed tab or the blue Error tab. See Chapter 6, "Debugging Test Problems," for more information.

### A.2 How do I restart a crashed test run?

If you need to restart a test run, you can figure out which test crashed the test suite by looking at the `harness.trace` file. The `harness.trace` file is in the report directory that you supplied to the JavaTest GUI or parameter file. Examine this trace file, then change the JavaTest GUI initial files to that location or to a directory location below that file, and restart. This will overwrite only `.jtr` files that you rerun. As long as you do not change the value of the GUI work directory, you can continue testing and then later compile a complete report to include results from all such partial runs.

### A.3 What would cause tests be added to the exclude list?

The JavaTest exclude file (`<TS_HOME>/bin/ts.jtx`) contains all tests that are not required to be run. The following is a list of reasons for a test to be included in the Exclude List:

- An error in a reference implementation that does not allow the test to execute properly has been discovered.

- An error in the specification that was used as the basis of the test has been discovered.

- An error in the test has been discovered.

Copyright © 2018, Oracle and/or its affiliates. All rights reserved.